VTech VT 1901 manual Getting Started, AC Power Adaptor, Handset Ringer

Page 15

GETTING STARTED

SETTING UP YOUR VTECH VT 1901 Choose an area near an electrical outlet and a telephone wall jack.

AC POWER ADAPTOR

Plug the AC power adaptor into an electrical outlet and the DC connector to the back of the base unit.

TELEPHONE

WALL JACK

AC

OUTLET

DC 9V TEL LINE

HANDSET RINGER

The handset ringer is programmed ON as the factory default setting. Refer to PROGRAMMING THE RINGER on page # for more information.

SETTING THE TONE/PULSE SWITCH The TONE/PULSE switch is located on the bottom of the base unit and is factory set to TONE. If you have touch tone service, do not change the switch setting. If you have rotary (Pulse) service, set the switch to PULSE.

PULSE

	TONE PULSE
TONE	SELECTION
TONE

CHARGE THE HANDSET BATTERY PACK BEFORE USE

The battery pack recharges automatically whenever the handset is in the base unit. The battery pack must be charged for 16 hours before using your phone for the first time.

POWER

IN-USE

CHARGING

SPARE BATT

CHARGE THE

HANDSET

BATTERY PACK

FOR 16 HOURSDIGIT

CORDLE

BEFORE USING

CONNECT TELEPHONE LINE CORD Plug one end of the telephone cord into a wall jack, and the other end into the back of the Base Unit.

15

1901MANUAL

15

1/28/99, 3:29 PM

Image 15

Contents Introduction Special Features Parts Check List Antenna Handset LayoutBase Unit Layout FCC Part FCC and IC RegulationsFCC and IC Regulations FCC and IC Regulations Read and understand all instructions Important Safety InstructionsIf the product exhibits a distinct change in performance Replacing the Handset Battery Pack To Charge The Battery PackMUTE/LO Batt LED is slowly flashing Downward Follow the steps belowSpare Battery Charger InstallationWord about Rechargeable Batteries Power Backup Handset Ringer AC Power AdaptorCharge the Handset Battery Pack Before USE Getting StartedCheck for a Dial Tone I N G T H E WA L L M O U N T Adaptor Wall MountingQuick Reference Guide Quick Memory Dialing Using RedialStoring Memory Dial Numbers Memory DialingBasic Operation Advanced Functions Temporary ToneChanging Ringer Types Turning OFF the Ringer Memory Speed Dialing Storing Memory DialNumbers Dialing from Memory Using RedialDialing from Memory Storing NumbersPress Hold pause Storing Special CodesDeleting Stored Electrical storms MaintenanceCleaning your telephone K I N G C a R E O F Y O U R TelephoneNoise or Interference OUT of Range When Phone is onOUT of Range When Phone is OFF Additional Operating TipsCase of Difficulty Phone DOESN’T Work AT ALLNo Dial Tone Common Cure for Electronic Equipment YOU Hear Other Calls While Using Your PhoneFor HOW Long After the Original PURCHASE? What does OUR Warranty COVER?HOW do I Send MY UNIT, in or OUT of WARRANTY? What does OUR Warranty not COVER?Technical Specifications Table of Contents Issue