VTech VT 1901 manual Wall Mounting, I N G T H E WA L L M O U N T Adaptor

Page 17

WALL MOUNTING

U S I N G T H E WA L L M O U N T ADAPTOR

1.Choose a spot near an electrical outlet and a telephone jack. You phone requires a modular telephone jack and a standard electrical outlet (120v AC). The power cord is six feet long; make sure there is an electrical outlet within reach of the Base Unit. The outlet should not be controlled by a wall switch. If the switch is ever turned off, the phone will not operate.

2.Position the wall mount bracket on the base.

Line up the tabs on the wall mount adaptor with the holes on the bottom of the base (Figure 1). Snap the wall mount bracket firmly in place.

3.Mount the base on the wall. Position the base so the mounting studs will fit into the holes on the bottom of the base. Position the power cord to extend down the wall the phone is to be mounted on. Slide the base down on the mounting studs until it locks into place.

4.Connect the telephone line cord. The telephone line cord has a snap-in plug at each end. Insert one of the plugs into the jack on the bottom of the base. Insert the other end of the plug into the wall jack.

5.Plug the AC adaptor into an electrical outlet and the DC connedor on the back of the Base Unit.

PULSE

TONE

Figure 1

4

5

6

7HS IN-USE

8

9

10

CHARGING

SPARE BATT

PAGE

CORDLESSDIGITAL900MHz

Figure 2

17

1901MANUAL

17

1/28/99, 3:29 PM

Image 17

Contents Introduction Special Features Parts Check List Antenna Handset LayoutBase Unit Layout FCC Part FCC and IC RegulationsFCC and IC Regulations FCC and IC Regulations Read and understand all instructions Important Safety InstructionsIf the product exhibits a distinct change in performance MUTE/LO Batt LED is slowly flashing Replacing the Handset Battery PackTo Charge The Battery Pack Downward Follow the steps belowWord about Rechargeable Batteries Spare Battery ChargerInstallation Power Backup Charge the Handset Battery Pack Before USE AC Power AdaptorGetting Started Handset RingerCheck for a Dial Tone I N G T H E WA L L M O U N T Adaptor Wall MountingQuick Reference Guide Storing Memory Dial Numbers Using RedialMemory Dialing Quick Memory DialingBasic Operation Changing Ringer Types Advanced FunctionsTemporary Tone Turning OFF the Ringer Numbers Memory Speed DialingStoring Memory Dial Dialing from Memory Using RedialStoring Numbers Dialing from MemoryDeleting Stored Press Hold pauseStoring Special Codes Cleaning your telephone MaintenanceK I N G C a R E O F Y O U R Telephone Electrical stormsOUT of Range When Phone is OFF OUT of Range When Phone is onAdditional Operating Tips Noise or InterferenceNo Dial Tone Case of DifficultyPhone DOESN’T Work AT ALL Common Cure for Electronic Equipment YOU Hear Other Calls While Using Your PhoneHOW do I Send MY UNIT, in or OUT of WARRANTY? What does OUR Warranty COVER?What does OUR Warranty not COVER? For HOW Long After the Original PURCHASE?Technical Specifications Table of Contents Issue