Setup
1.Plug the AC power adapter into an electrical outlet, and the DC connector into the back of the base unit.
To AC outlet
To telephone socket outlet
AC adapter | To telephone |
| jack |
Connecting to phone line
Plug one end of the telephone line cord into the jack on the back of the base unit. Plug the other end of this cord into the wall jack.
Checking for dial tone
After the battery is charged press ON on the Handset. The Phone icon will appear on the handset display, and you will hear dial tone. If not, see In Case of Difficulty.
Tone/Pulse selection
The TONE/PULSE switch is located on the bottom of the Base Unit, next to the telephone jack. It is factory set to TONE. If you have rotary (Pulse) service, set the switch to
PULSE.
CAUTION: Use only the 7 volt power adaptor provided with your GIGAPHONE.
IMPORTANT:
FOR MAXIMUM PERFORMANCE OF
YOUR CORDLESS TELEPHONE SYSTEM:
1. Choose a central location for your Base Unit.
2. Install your Base Unit and Extension Handsets away from electronic equipment, such as personal computers, television sets and microwave ovens.
3. In locations where there are multiple cordless telephones, separate base units as much as possible.
4. Install your telephone equipment away from heat sources and sunlight.
5. Avoid excessive moisture, dust or extreme cold.
Getting Started
7