GETTING STARTED
Setup
Installation of Battery Pack in Handset
| Follow the steps below: | ||
1 | 1. | Remove the battery cover by | |
3 | pressing on the indent and sliding | ||
| |||
|
| downward. | |
| 2. | Place the new battery pack in the | |
|
| Handset with the metal contacts | |
|
| aligned with the charge contacts | |
|
| in the battery compartment. | |
| 3. | Replace the battery cover by sliding | |
|
| it upwards. | |
| 4. | If the new battery pack is not | |
|
| already charged, place the Handset | |
|
| in its Charger, and allow it to | |
|
| charge for 12 hours. After initial | |
| 2 | charge, a maintenance charge of | |
|
| 8 hours should be sufficient. | |
The original Handset that is shipped with your VT5831 system will be automatically registered to the Base. This Handset is HANDSET 1.
As you register additional Handsets to the system, they will be assigned extension numbers in the following order: HANDSET 2, HANDSET 3, etc.
Whenever a charged Handset battery pack is installed, the Handset will automatically begin SEARCHING FOR BASE (if previously registered), or it will prompt you to ENTER BASE ID to register the new Handset.
Charging of the Handset Battery Pack
The Handset of your VT5831 cordless telephone is powered by a rechargeable battery pack. It charges automatically whenever the Handset is in its charger.
You should charge the battery pack for 12 hours when you first receive your phone. You’ll know the battery pack needs charging when:
• The low battery message is displayed :
• The Handset seems completely dead, the LCD is completely clear and does not ac- tivate when you press the keys.
8