VTech 5831 important safety instructions Registration, Enter Base ID Code

Registration

Enter Base ID Code

1. After charging the Handset, remove it from its Charge Cradle; the screen will display:

alternating with this screen:

2.If, after charging the Handset, you see:

3.Press NEW. You will now see the ENTER BASE ID screen as described in step 1.

4.Find the BASE ID Code by doing the following: (the Base must be in idle (OFF) mode)

A.At the Base, press MENU

B.Scroll down to DISPLAY BASE-ID

C.Press OK. The Base screen will display the 15-digit ID Code. Afterwards, it will return to the idle screen.

5.Enter the 15-digit Base ID Code into the Handset; then press OK.

NOTE: The 15-digit BASE ID Code may contain numbers and characters, such as *. Make sure you enter all 15 digits.

6.Wait approximately 15 to 60 seconds. You will hear confirmation beeps from the Base and Handset. The newly registered Handset will now assign itself the lowest Handset number not previously assigned to a different system Handset (1 through 6).

7.If the Handset displays REJECTED BY BASE or continues to display SEARCHING FOR BASE for well beyond 60 seconds, try the

registration process again by repeating the above steps.

Congratulations! You can now enjoy the benefits of your VTECH Multi-Handset system.

6