Avaya NN43110-301, 1100 Series manual Connecting the Expansion Module

Page 16

Setup and assembly

Figure 3: Connecting the Expansion Module

4.If connecting a second, or a third Expansion Module, repeat steps 2 to 4.

Note: The second Expansion Module is attached to the right side of the first Expansion Module. The third Expansion Module is attached to the right side of the second Expansion Module.

5.Adjust the height of the IP Deskphone tilt adjustment to a comfortable viewing angle. Then adjust each of the Expansion Module footstands so they are flush to the desk surface. Turn the wheel on the back right side of the Expansion Module to the right (if viewed from the front) to tighten the Expansion Module.

WARNING

Do not over tighten the wheel on the Expansion Module.

6.Connect power to the IP Deskphone. The Expansion Module powers up.

Note: The Expansion Module uses the electrical connection of the IP Deskphone for power. It does not have its own power source.

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Communications Server Downloading documents Contact Avaya Support Contents Contents Regulatory and safety information Other Jurisdiction Standard DescriptionDenAn regulatory notice for Japan Regulatory and safety information Introduction DescriptionFeatures Avaya 1100 Series Expansion ModuleCall Server Support Avaya 1100 Series Expansion Module displayBacklight Icons Setup and assembly Installing the Avaya 1100 Series Expansion ModuleAdjusting the stand angle on the IP Deskphone Connecting the Expansion Module Phase Description Avaya 1100 Series Expansion Module startup initializationUsing the wall-mount option Adjusting the tilt baseSetup and assembly Avaya 1100 Series Expansion Module programming
Top Page Image Contents