Avaya 1100 Series, NN43110-301 manual Adjusting the stand angle on the IP Deskphone

Page 15

Setup and assembly

1.Press the tilt lever to adjust the stand angle on the IP Deskphone. You can adjust the stand angle to maximum, instead of removing the stand. See Figure 2.

Figure 2: Adjusting the stand angle on the IP Deskphone

Accessory Expansion Module (AEM) Port

Wheel

Tilt

Lever

Clamp

2.At the back of the IP Deskphone, remove the rubber plug from the AEM port. Place the connecting arm of the Expansion Module behind the IP Deskphone and align the Expansion Module connection plug to the AEM port on the back of the IP Deskphone.

3.Insert the screws in to the top and bottom holes of the connecting arm of the Expansion Module and tighten until snug. See Figure 3 on page 16.

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Communications Server Downloading documents Contact Avaya Support Contents Contents Regulatory and safety information Jurisdiction Standard Description OtherDenAn regulatory notice for Japan Regulatory and safety information Description IntroductionAvaya 1100 Series Expansion Module FeaturesAvaya 1100 Series Expansion Module display Call Server SupportBacklight Icons Installing the Avaya 1100 Series Expansion Module Setup and assemblyAdjusting the stand angle on the IP Deskphone Connecting the Expansion Module Avaya 1100 Series Expansion Module startup initialization Phase DescriptionAdjusting the tilt base Using the wall-mount optionSetup and assembly Avaya 1100 Series Expansion Module programming
Top Page Image Contents