Installation and Setup
5.Loosen the screws from the existing telco wall plate enough so that the Wall Mount Base is able to slide in place. or
Remove the screws from the existing telco wall plate entirely and replace with a set of the provided screws. Ensure that the screws are loose enough so that the Wall Mount Base is able to slide in place.
Note:
Depending on the wall type, you may need to use wall anchors. Two wall anchors are included with your 6867i IP Phone.
v
6.Align the Wall Mount Base above the screw heads (ensuring the Vertical Screw Lock Hole is facing up) on the telco wall plate and pull down to lock the Wall Mount Base in place.
Telco
Wall
Plate
| Wall Mount Base Secured | |
Align and Pull Down | ||
to Telco Wall Plate | ||
|
7.On the back of your phone, connect the provided Ethernet cable into the network port marked with 
. Plug the other end of the Ethernet cable directly into the network jack on the wall.
14 |