JVC GR-DVL120 Basic Recording, Shooting while using the viewfinder Close the LCD monitor

Page 15

RECORDING

EN 15

Power lamp

Power Switch

 

Lock Button

During

 

shooting

 

 

Recording Start/Stop Button

 

Display

 

 

 

25min Tape remaining time

 

 

 

 

indicator (Approximate)

 

 

 

min 90 min 89 min 3 min

(Now calculating)

0 min 1 min 2 min

(Blinking) (Blinking) (Blinking)

BR I GHT

MENU/BRIGHT Wheel

PUSH OPEN Button

Basic Recording

NOTE:

You should already have performed the procedures listed below. If not, do so before continuing.

Power ( pg. 8)

Grip Adjustment ( pg. 10)

Viewfinder Adjustment ( pg. 10)

Load A Cassette ( pg. 12)

Recording Mode Setting ( pg. 13)

1 Remove the lens cap.

2 Set the Power Switch to “” or “ ” while pressing down the Lock Button located on the switch. Shooting while using the LCD monitor: Make sure the LCD monitor is fully open. Tilt it upward/ downward for best viewability.

Shooting while using the viewfinder: Close the LCD monitor.

The power lamp lights and the camcorder enters the Record-Standby mode. “PAUSE” is displayed.

3 Press the Recording Start/Stop Button. “” appears while recording is in progress.

To Stop Recording . . .

..... press the Recording Start/Stop Button. The

camcorder re-enters the Record-Standby mode.

To Adjust The Brightness Of The Display . . .

..... rotate the MENU/BRIGHT wheel until the bright

level indicator on the display moves and the appropriate brightness is reached.

NOTES:

If the Record-Standby mode continues for 5 minutes, the camcorder’s power shuts off automatically. To turn

the camcorder on again, set the Power Switch to “OFF”, then back to “” or “ ”.

The image will not appear simultaneously on the LCD monitor and the viewfinder. It will appear in the viewfinder when the LCD monitor is in the lock position, and it will appear on the LCD monitor when fully extended.

When a blank portion is left between recorded scenes on the tape, the time code is interrupted and errors may

occur when editing the tape. To avoid this, refer to “Recording from the middle of a tape” ( pg. 18).

To turn the beep sounds off,  pg. 32, 34.

For other notes,  pg. 47

Image 15
Contents GR-DVL120 It is recommended that you Dear CustomerPage Before recording an important scene Shoulder Strap How To Attach The Lens CapPower Cord AttachmentHow To Attach The Core Filter MENU/BRIGHT Wheel Lock Button Power Switch Sub MenuStopper Wind once Getting Started Charging time PowerTo Detach The Battery Pack Press BAT. Release and pull out the battery PackAbout Batteries Approximate recording timeBenefits Of Lithium-Ion Batteries Shoulder Strap Attachment Grip AdjustmentViewfinder Adjustment 10 ENDate/Time Settings Approximate recording time Tape Recording mode 12 ENLoading/Unloading a Cassette Audio Dubbing  pg and Insert Editing Recording Mode SettingSet the tape recording mode depending on your preference SP mode14 EN To Stop Recording Shooting while using the viewfinder Close the LCD monitorTo Adjust The Brightness Of The Display Basic RecordingOperation Mode Power Switch Position16 EN Zoom in T Telephoto Slide the Power Zoom Lever towards TZoom Zoom OutProper recording When a blank portion is recorded on a tape18 EN Time CodeNormal Playback To Control The Speaker VolumeConnections 20 ENIf using a VCR . . . go to step If not . . . go to step Press Blank Search To cancel Blank Search midway22 EN Blank SearchAdvanced Features To Deactivate Night-Scope To Deactivate The Selected Mode24 EN Night-ScopeYour recording looks like a series of consecutive snapshots Sports Variable Shutter Speed 1/250 1/4000Makes evening scenes look more natural Gives recorded scenes a strobe effect26 EN Fade/Wipe EffectsTo Deactivate The Selected Effect Menu Effect Fader And Wipe MenuSnapshot 28 ENSubject While focusing on a nearer subjectTo obtain correct focus Focus detection zone30 EN Exposure ControlIris Lock White Balance Adjustment Manual White Balance OperationTo Return To Automatic White Balance If you have selected CAMERA, Manual System or Display 32 ENFor Recording Menu See pg40X Factory-presetMenu Screen Explanations 16XRecording. Also to activate the shutter sound effect  pg Screen ratio becomes Appears. When using this mode, referNormal screen ratio Screen and the image appears like a letterboxed 169 movieResets all settings to the factory-preset When the Menu Screen is closed after Demo Mode is turned onAfter the Power Switch is set to or Does not reset all settings to the factory-presetFor Playback Menu 36 ENDisplay Playback Sound38 EN Dubbing To a VCRDate/Time Set DATE/TIME to AUTO, on or OFF Menu Screen  pg DV cable To use this camcorder as a playerTo DV Core filter Lock Button40 EN Lock holeKnob Remote sensor This function is unavailable with this camcorder 42 EN Remote sensor RM-V700U optional Zoom ButtonsNormal playback Press T Set 12BIT Mode to Sound 2 or MIX Menu Screen  pg Audio DubbingTo hear the dubbed sound during playback Lock Button Power Switch Display 44 ENInsert Editing System Connections 46 EN Detach the battery from the camcorder Charging times are for a fully discharged battery packBattery pack Set the Power Switch to PLAY, or48 EN For replacementFind a white subject and compose Colour of SnapshotModes of Programme AE with 50 ENMenu Screen Menu Screen  pg Image colour on the LCD Edge of the LCD monitor isRmonitor or the viewfinder 52 EN Remove Cleaning The CamcorderOPEN/EJECT Switch BAT. Release Button Hatch Lens blower After UseDuring use To prevent damage and prolong service life54 EN To avoid hazardsTo prevent damage to the LCD monitor, do not To prolong service lifeFor safety, do not Avoid using the unitSerious malfunctioning Dirty heads can cause the following problems56 EN About moisture condensationWeight Power supplyPower consumption Dimensions W x H x D5 6 58 ENLCD Monitor Bright Brightness Audio/Video Output ConnectorVideo Output Connector Digital Video ConnectorLCD Monitor/Viewfinder Indications During Recording 60 ENBright Displays the brightness Displays the sound modeLCD Monitor/Viewfinder Indications During Playback 116 21Index Indications 62 ENDarken The LCD Monitor Backlight Compensation pg , 9 Channels Left/RightSee previous page as well Pg , 35Unload a Tape White Balance