6 EN
1Attach the Core Filter(s)2(if provided with your model pg. 5) to an optional cable(s)3. The Core Filter reduces interference.
How To Attach The Core Filter
3 cm
Stopper | Wind once |
|
|
| |
Release the | Run the cable through the Core Filter, leaving approx. | Close the Core Filter until it |
stoppers on both | 3 cm of cable between the cable plug and the Core Filter. | clicks shut. |
ends of the Core | Wind the cable once around the outside of the Core Filter |
|
Filter. | as shown in the illustration. |
|
| • Wind the cable so that it is not slack. |
|
| NOTE: |
|
| Take care not to damage the cable. |
|
When connecting cables, attach the end with the Core Filter to the camcorder.
AUTOMATIC DEMONSTRATION
Automatic Demonstration takes place when “DEMO MODE” is set to “ON”
Automatic Demonstration starts when there is no operation for about 3 minutes after the Power Switch is set to “ 
” or “ 
” and no cassette is in the camcorder.
Performing any operation during the demonstration stops the demonstration temporarily. If no operation is performed for more than 3 minutes after that, the demonstration will resume.
“DEMO MODE” remains “ON” even if the camcorder power is turned off.
To cancel Automatic Demonstration:
1.Set the Power Switch to “ 
” while pressing down the Lock Button located on the switch and press the MENU/BRIGHT wheel in. The Menu Screen appears.
2.Rotate the MENU/BRIGHT wheel to select “ 
SYSTEM” and press it. The SYSTEM Menu appears.
3.Rotate the MENU/BRIGHT wheel to select “DEMO MODE” and press it. The Sub Menu appears.
4.Rotate the MENU/BRIGHT wheel to select “OFF” and press it.
5.Rotate the MENU/BRIGHT wheel to select “ 
RETURN”, and press it twice. The normal screen appears.
NOTE:
MENU/BRIGHT Wheel
Lock Button
Power Switch
Sub Menu
DEMO MODE – OF F
ON
If you do not detach the Lens Cap, you cannot see the actual changes of the Automatic Demonstration activated on the LCD monitor or viewfinder.