JVC GR-DVL120 specifications 52 EN

52 EN				TROUBLESHOOTING (cont.)
	o
		SYMPTOM	POSSIBLE CAUSES		CORRECTIVE ACTION
		The LCD monitor, the			• Wipe them gently with soft cloth.
		viewfinder and the lens	————		Wiping strongly can cause damage
		have become dirty (ex.			( pg. 53).
	pfingerprints).
	QAn unusual mark appears.				• Check the section of the manual
			————		that explains LCD monitor/
					viewfinder indications
					( pg. 60 – 62).
		An error indication	• A malfunction of some kind has		• Remove the power supply (battery
	W(E01, E02 or E06) appears.		occurred. In this case the		pack, etc.) and wait a few minutes
			camcorder’s functions become		for the indication to clear. When it
			unusable.		does, you can resume using the
					camcorder. If the indication
					remains even though you repeat
					the above two or three times,
					please consult your nearest JVC
					dealer. Do not eject the cassette.
					This will cause damage to the tape.
		An error indication	• A malfunction of some kind has		• Eject the cassette once and re-
	E(E03 or E04) appears.		occurred. In this case the		insert it, then check if the indication
			camcorder’s functions become		clears. When it does, you can
			unusable.		resume using the camcorder. If the
					indication remains even though
					you repeat the above two or three
					times, please consult your nearest
					JVC dealer.
		The charger indicator on	• The temperature of the battery is		• To protect the battery, it is
		the camcorder does not	extremely high/low.		recommended to charge it in
	Rlight.		• Charging is difficult in places		places with a temperature of 10°C
			subject to extremely high/low		to 35°C ( pg. 54).
			temperatures.
		When the image is printed	• This is not a malfunction.		• By recording with “DIS” activated
		from the printer, a black bar			( pg. 33) this can be avoided.
		appears at the bottom of
	Tthe screen.
		When the camcorder is	• The DV cable was plugged/		• Turn the camcorder’s power off
		connected via the DV	unplugged with power turned on.		and on again, then operate it.
		connector, the camcorder
		does not operate.