AT&T AT3101 user manual Belt clip & optional headset, Installation, Removal

Page 10

Getting started

Belt clip & optional headset

Install belt clip as shown below if desired:

Installation

Snap belt clip into notches on both sides of handset.

IC:xxxxX-xxxxxxxx FCC ID: XXxxx-xxxx-xx

IC:xxxxX-xxxxxxxx FCC ID: XXxxx-xxxx-xx

Removal

Pull and unlock one flap from the notch first before detaching the whole belt clip from handset.

For hands-free telephone conversations, use any industry standard 2.5mm headset (purchased separately). For best results, use a AT&T 2.5mm headset.

NOTE: If the sound quality of the headset is not satisfactory, try unplugging it, and firmly plugging it in again.

Plug the 2.5 mm headset into the jack on the side of the handset (beneath the small rubber flap).

HANDSET 1

Image 10

Contents

AT3101 User’s manualCongratulations On purchasing your new AT&T productStop Parts checklist Table of contentsCharger installation Battery installation & charging Important InformationAdding your new handset To register a handset to your telephone baseReplacing a handset To de-register all handsetsCID caller ID Handset layout15. # Belt clip & optional headset InstallationRemoval Troubleshooting Troubleshooting Connecting Please refer to the Battery installation This Troubleshooting guideNot come on, refer to The charge light is off Troubleshooting Troubleshooting Test a working phone at the phone jack. If Relocate your telephone base to a higher Troubleshooting Troubleshooting Important safety instructions Important safety instructions Important safety instructions Precautions for users of implanted cardiac pacemakers Pacemaker patientsFCC Part 68 & Acta FCC Part 68 and Acta FCC Part 68 and Acta FCC Part FCC Part Limited warranty Limited warranty Limited warranty Limited warranty Dect 6.0 digital technology Technical specificationsTelephone operating range