AT&T E1112B, E2912B user manual Message counter displays

Answering system operation

	Message counter displays
	The message counter usually displays the total
	number of memos and incoming messages. See the
	list below for explanations of other displays in this
Message counter	counter.
	Message counter displays

0		No messages.
0 (flashing)		The clock needs to be set (page 36).
1-99		Total number of messages and memos, or
		message number currently playing.
1-99(flashing)		Total number of messages and memos.
		The number flashes when there are new
		(un-reviewed) messages.
		If the telephone loses power, after power
		is restored, the number in the message
		counter will flash to indicate the clock
		needs to be set.
	10-99	Current remote access code while setting
		(page 38).
1-99(counting)		Elapsed time while recording a memo
		(page 40) or announcement up to 90 sec-
		onds (page 37).
99 (flashing)		Memo recording time has exceeded the
		maximum counter capacity of 99 seconds.
F (flashing)		Memory is full. Messages must be deleted
		before new messages can be received.
--		System is answering a call, being
		accessed remotely, or the clock is being
		set.
--(flashing)		System is being setup or initialized.
02, 04, 06, tS		Current number of rings while setting
		(page 38).
1-8		Displayed for two seconds while telephone
		base speaker volume being adjusted.
HI, LO, OF		Displayed for two seconds while telephone
		base ringer volume being adjusted.

41