AT&T 9341 user manual Installation, Before You Install

Page 6

9341_book_1ATT 6/14/00 4:07 PM Page 4

INSTALLATION

Before You Install

1Choose a location for the base near an electrical outlet and a telephone jack.

This phone requires a modular telephone jack and a standard electrical outlet (110v AC) not controlled by a wall switch.

2Install the handset battery.

a)Remove battery

compartment cover by pressing on the indentation

and sliding downward.

b) Align two holes in plug with socket pins, and snap the plug into place.

c)Place battery pack

in compartment with the wires in the lower left corner, along the bottom of the battery pack.

d) Replace cover by sliding it up into place.

4

Image 6

Contents MHz Cordless Telephone With Caller ID/Call Waiting Advanced American Telephones. All rights reserved Contents 9341book1ATT 6/14/00 407 PM Before YOU Begin About Caller Identification Caller IDInstallation Before You InstallTable/Desk Installation Wall Installation Check for dial toneFollow Steps 3-5 in Table/Desk Installation Ringer Selection Feature SettingsTime/Date Auto Answer On/OffTelephone Operation Handset Locator Temporary Tone Dialing Headset JackOperating Range Display Screen MessagesTelephone Memory Store Memory NumbersMove Numbers Stored in Memory Edit Numbers Stored in MemoryDelete Numbers Stored in Memory Delete a Specific NumberDial Memory Numbers Caller ID Operation About Call HistoryReview Call History Delete a Specific Call Delete Call HistoryDial a Displayed Number Delete All CallsStore Call in Memory To LOCATION?Call Block Turn Off Call BlockPrivate Name Charging the Handset Battery Pack BatteriesReplacing the Handset Battery Pack If the phone does not ring when you receive a call Case of DifficultyIf the phone doesn’t work at all, check these items first If you hear noise or interference when using the phone If you hear other calls while using your phoneIf you lose a call after changing channels