Getting started
Telephone base installation
1.Plug the small end of the larger power adapter into the power jack at the bottom of the tele- phone base.
2. Plug one end of the
telephone line cord into the telephone jack at the bottom of the telephone base.
5. Plug the other end of the telephone line cord into a telephone jack.
Telephone line cord
DSL filter
(Optional for DSL users, see number four in the note section, below.)
NOTES:
3.Route cords through slots.
4.Plug the large end of the larger power adapter into an electrical outlet not controlled by a wall switch.
1. Use only the power adapter supplied with this product or equivalent. To order a replace-
ment power adapter, visit our website at www.telephones.att.com or call 1 (800)
2.Be sure to use an electrical outlet not controlled by a wall switch.
3.This power adapter is intended to be correctly oriented in a vertical or floor mount position.
4.If you receive high speed internet through your telephone line (commonly referred to as DSL), and you are experiencing interference during telephone conversations and/or your caller ID features are not functioning properly, install a DSL filter to the telephone line between the telephone base and the telephone wall jack. Contact your DSL service provider for a DSL filter.
6