AT&T 8510T manual Switch Features, Gray Type

Switch Features

Since your 8510T voice terminal is connected to a DEFINITY Communications System Generic 1 or Generic 3, you may be able to use some of the following features. Check with your System Manager to see which of these features have been assigned to your voice terminal.

Special Instructions

Before you use these procedures for the first time, read the general directions below for using the many features of DEFINITY Generic 1 and Generic 3. Your System Manager can supply the information required.

●To the right of each of the feature name is a box. Check with your System Manager to see which features you can use at your voice terminal. For each feature that you have, mark a [ ✔ ] in the blank box as a reminder.

●You can activate or cancel most of the features by dialing unique 2- or 3-digit codes for that feature. Ask your System Manager for the feature codes for your system. Then, in the blanks provided within the procedures, write in the assigned feature code numbers.

●In many case, before you begin a procedure, you must have the handset off- hook (removed from the cradle of the voice terminal).

●If you receive an intercept tone (high-pitched, alternating high and low tone) while attempting to operate any feature, you have taken too much time to complete a procedural step or have made a dialing error. Hang up, wait for dial tone, and begin again at Step 1.

Conventions

The following conventions are used in the procedures in this section:

Gray Type	Procedural steps in gray type are steps that you
	should follow if you do not have a button assigned for
	the feature.

[ xxxxx ]	This box represents a call appearance button, which is
	used exclusively for placing or receiving calls. The
	button has a red in-use light and a green status light
	and is labeled with an extension number (shown as
	xxxxx).

11