AT&T HS8201 user manual Telephone Operation

Page 10

TELEPHONE OPERATION

Handset Volume

Adjust volume of what you hear through the handset.

Make or

Answer a Call

Lift handset from base

— OR —

Press Pand wait for light to go on steadily.

Flash/

Call Waiting

Access special telephone company subscriber services.

Redial

Follow the instructions under “Make or Answer a Call,” then press Rto call the last number dialed (up to 24 digits).

End a Call

Place handset

in base

— OR —

Press O.

Exit

programming.

Cancel a page.

Change Channel

Switch to a

clearer channel.

On steady:	Blinking:
Handset in use	Programming mode
Flashing:	Flashing slowly:
Line ringing	Battery low

8

Image 10

Contents MHz Cordless Telephone HS-8201 Part 1 Important Product InformationAdvanced American Telephones. All rights reserved Contents Page Before You Install InstallationInstall the handset battery Attach the belt clip to the cordless handset optional Set the dial mode Table/Desk InstallationCheck for dial tone Connect the telephone line cord Connect the power cord Wall InstallationPosition the wall mount adapter on the base Follow Steps 3-5 in Table/Desk Installation Mount the base on the wallTelephone Operation Telephone Operation Temporary Tone Dialing Ringer Off/Battery SaveHandset Ringer Style Headset Jack Operating RangeTelephone Memory Charging the Handset Battery Pack BatteriesReplacing the Handset Battery Pack Case of Difficulty If the phone does not ring when you receive a callIf the phone doesn’t work at all, check these items first If you hear other calls while using your phone If you hear noise or interference when using the phoneIf you lose a call after changing channels