AT&T HS8201 user manual Table/Desk Installation, Check for dial tone, Set the dial mode

Page 7

INSTALLATION

Table/Desk Installation

Standard

Modular

electrical outlet

telephone

jack

1 Connect the telephone line cord.

2Connect the power cord.

3Charge the handset battery.

Place the handset in the base. Charge the battery for at least 24 hours the first time. After the first charge, the battery is typically fully charged overnight.

4Check for dial tone.

After the batteries are charged, pick up the handset and press P; you should hear a dial tone.

5Set the dial mode.

If you have touch tone service, the phone is ready to use as soon as the batteries are charged.

If you have dial pulse (rotary) service, you’ll need to change the dial mode. When the phone is off, press G, *, #, Mto set the dial mode to dial pulse. To return to touch tone dialing, press G,

*, *, M.

5

Image 7

Contents Part 1 Important Product Information MHz Cordless Telephone HS-8201Advanced American Telephones. All rights reserved Contents Page Before You Install InstallationInstall the handset battery Attach the belt clip to the cordless handset optional Set the dial mode Table/Desk InstallationCheck for dial tone Connect the telephone line cord Connect the power cord Wall InstallationPosition the wall mount adapter on the base Mount the base on the wall Follow Steps 3-5 in Table/Desk InstallationTelephone Operation Telephone Operation Temporary Tone Dialing Ringer Off/Battery SaveHandset Ringer Style Operating Range Headset JackTelephone Memory Batteries Charging the Handset Battery PackReplacing the Handset Battery Pack Case of Difficulty If the phone does not ring when you receive a callIf the phone doesn’t work at all, check these items first If you hear other calls while using your phone If you hear noise or interference when using the phoneIf you lose a call after changing channels