Wall mounting, Belt clip & optional headset

Getting Started

Wall mounting

The telephone base can be installed on any standard wall-phone outlet as shown below. Choose a location away from electronic equipment, such as personal computers, television sets or microwave ovens. Avoid excessive heat, cold, dust or moisture.

Connect telephone line cord and AC	Swivel wall mount down
adapter as shown on page 6. Press	and lock in place
plastic tabs inside notches to release
and open hinged wall mount.

Press and slide down firmly so base is held securely on outlet mounting pegs

Plug short telephone line cord into telephone jack

Plug base power cord transformer into electrical outlet

Getting Started

Belt clip & optional headset

Install belt clip as shown below if desired.

For hands-free telephone conversations, you can use any industry standard 2.5 mm headset (purchased separately). For best results use an AT&T 2.5 mm headset.

Snap belt clip into notches on side of handset. Rotate and pull to remove.

Plug 2.5 mm headset into jack on side of handset (beneath small rubber cap)