AT&T 1256 user manual Wall Installation

Wall Installation

1Press the tabs as indicated (figure a).

2Flip the base extension open (figure b).

3Run the line cord and the power cord through the opening in the

figure a	base extension and plug them
	into the jacks on the phone.
	(figure c).

	4	Connect the telephone line cord
		(figure e).
figure b	5	Connect the power cord
		(figure e).
		The ON/OFF light goes
		on,and flashes in the message
		window.
		Use only the power cord
		supplied with this product.
		If you need a replacement,
		call 1 800 222–3111.
	6	Snap the base extension down
		firmly (figure d).
figure c	7	Mount the base on the wall
		(figure e).
		a) Align holes on base with
		mounting studs on wall jack.
		b) Place power cord as shown.
		c) Pull base down on mounting
		studs until it locks into place.
figure d	8	Follow Steps 3–5 in “Table/Desk
		Installation.”

figure e

6