AT&T 1818 user manual AS48 Digital Answering System, Remote Commands

Page 13

05/01 1AT&T Issue .China in Printed .reserved rights All .Telephones American Advanced 2001 ©

fold

1

AS48 Digital Answering System

Remote Commands

To connect with your answering system:

1Dial your telephone number from a touch tone phone.

2When the system answers, enter your Remote Access Code. The system announces the number of messages and begins message playback.

3Listen to your messages

— OR —

Press 5during message playback and wait for the two-beep signal before entering a remote command from inside this card.

05/01 1AT&T Issue .China in Printed .reserved rights All .Telephones American Advanced 2001 ©

fold

1

AS48 Digital Answering System

Remote Commands

To connect with your answering system:

1Dial your telephone number from a touch tone phone.

2When the system answers, enter your Remote Access Code. The system announces the number of messages and begins message playback.

3Listen to your messages

— OR —

Press 5during message playback and wait for the two-beep signal before entering a remote command from inside this card.

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Digital Answering System Speakerphone Before You Install InstallationTable/Desk Installation BatteriesFollow Steps 6 8 under Table/ Desk Installation Wall InstallationReverse the handset tab Feature Summary Feature SetupA T U R E S E T U P Turn System On/OffReview Feature Setup Feature Summary cont’dM O T E O P E R a T I O N Remote Access CommandsConnect with the Answering System Ringer Volume Dial ModeHandset Speakerphone Volume Control HoldErasing Memory Numbers L E P H O N E M E M O RYRecord Your Announcement Set the ClockAnswering Calls Call Screening/InterceptMessage Listen To, Save & Delete MessagesPress to play only new messages F F I C U LT Y C a S E O FRecord a Memo Memory MonitorC a S E O F D I F F I C U LT Y AS48 Digital Answering System Remote CommandsONE KEY Remote Commands
Top Page Image Contents