AT&T 1818 user manual Feature Summary cont’d, Review Feature Setup

Page 5

F E A T U R E S E T U P

Feature Summary (cont’d)

Feature/System Announces

Options

 

 

Priority Call Code

Change the Priority Call Code to any three-digit

 

number from 500–999. Code is preset to 999. Do

 

not set to same number as Remote Access Code. See

 

“Priority Calling Code” under ANSWERING SYSTEM

 

OPERATION for information about using this feature.

Announcement Monitor

Choose ON to hear the announcement when your system answers a call. Choose OFF to have it silent on your end. (Your caller will still hear the announcement.)

NOTE: Volume must be set to a level you can hear to use Announcement Monitor.

Number Announce

(Please see NOTE below.)

When this feature is on the system will announce the caller’s telephone number between the second and third rings.

NOTE: When the Number Announce feature is on and Number of Rings is set for two rings or Toll Saver 2/4, the unit will answer after three rings to allow enough time for the system to announce the caller’s telephone number.

Store Number

When this feature is on, the system announces the

(Please see NOTE below.)

caller’s telephone number when it plays back a

 

message.

 

 

Accept Blocked Calls

Choose ON to have the system accept all calls.

(Please see NOTE below.)

Choose OFF to have the system respond to “blocked”

 

calls with the pre-recorded announcement, “We’re

 

sorry, blocked calls to this number cannot be

 

accepted,” and hang up without recording a message.

Call Screening

Set the system to play callers’ messages as they are recorded (ON) or to remain silent while callers are recording messages (OFF).

NOTE: Volume must be set to a level you can hear to use Call Screening.

Ring Select

Choose from four possible ringer tones. You will hear

“Selected ring is...”

a sample as you change the setting.

 

 

NOTE: For this feature to work, you must subscribe to Caller Identification service from your telephone service provider. There is a fee for this service, and it may not be available in all areas.

Review Feature Setup

To review the current feature settings, press and release S.

4

Image 5
Contents Digital Answering System Speakerphone Before You Install InstallationTable/Desk Installation BatteriesReverse the handset tab Wall InstallationFollow Steps 6 8 under Table/ Desk Installation Feature Summary Feature SetupA T U R E S E T U P Turn System On/OffReview Feature Setup Feature Summary cont’dConnect with the Answering System Remote Access CommandsM O T E O P E R a T I O N Ringer Volume Dial ModeHandset Speakerphone Volume Control HoldErasing Memory Numbers L E P H O N E M E M O RYRecord Your Announcement Set the ClockAnswering Calls Call Screening/InterceptPress to play only new messages Listen To, Save & Delete MessagesMessage F F I C U LT Y C a S E O FRecord a Memo Memory MonitorC a S E O F D I F F I C U LT Y AS48 Digital Answering System Remote CommandsONE KEY Remote Commands