A T U R E S E T U P, Turn System On/Off, Feature Setup

F E A T U R E S E T U P

Before proceeding to set up features, press

Oto turn the system on. The PLAY/ STOP light is on or blinking when the system is on.

1To enter Feature Setup mode, press and hold Suntil the system announces “Selected announcement is…”

2Press and release Suntil the system announces the feature you want to set.

3Press and release or until the system announces the setting you want. Refer to the Feature Summary for options.

4Press and release Sto set up the next feature listed on the Feature Summary

— OR —

Press and release Pto exit Feature Setup.

The new settings will be saved.

Feature/System Announces	Options

Announce Select	Choose to record an announcement, or use the
	pre-recorded announcement.
“Selected announcement is...”	• Select “Announcement A” when you want the
	system to record callers’ messages. Select
	“Announce Only” when you want the system to
	play an announcement and then hang up.
	• If you select “Announcement A” and do not
	record an announcement, the system plays the
	pre-recorded announcement: “Hello. Please
	leave a message after the tone.”
	• If you select “Announce Only” and do not record
	an announcement, the system will answer after
	10 rings and announce “No announcement.”
	See “Record Your Announcement” under ANSWERING
	SYSTEM OPERATION for recording instructions.

Number of Rings	Choose how many times the line will ring before the
	system answers a call.
“Number of rings is...”	• Set for 2 to 7 rings, or choose Toll Saver 2/4 or Toll
	Saver 4/6.
	• When set to Toll Saver 2/4, the system answers
	after four rings when you have no new messages
	and after two rings when you do. Toll Saver 4/6
	causes the system to answer after six rings when
	you have no new messages and after four rings
	when you do.

Audible Message Alert

When this feature is on, the system beeps every 15 seconds when you have new messages.

Remote Access Code	Change the Remote Access Code to any three digit
	number from 500 to 999. Do not set to same number
	as Priority Calling Code.
“Remote access code is...”	• The Remote Access Code, preset to 500, allows
	you to access many features of this answering
	system remotely from a touch tone phone.
	• The system will prompt you to repeat Steps 2
	and 3 of Feature Setup until you have set all
	three digits.