2.Place the parent unit on the charger. The red charging light illuminates.
NOTE
It takes about 15 hours to charge the unit.
3.Press P. The LCD display will illuminate.
4.Press and hold Pto switch off the parent unit.
2.5Link
NOTE
Do not place the baby unit or cables in the cot or within arm's reach of the baby (the unit should be at least 1 metre away).
When using the baby monitor for the first time, it is advised to test the connection.
•Install the parent unit in the same room as the baby unit, but make sure there is at least 1 metre between the 2 units to avoid feedback howling.
•When both units are switched on, the parent unit will search for the baby unit.
•The green link LED on the parent unit will flash until the parent unit is connected with the baby unit.
Once the link is established, the LED will stop flashing.
•The sound captured by the microphone on the baby unit will be audible on the parent unit.
•The detected sound level is indicated by the LEDs near the top of the parent unit.
•When the sound reaches the maximum level, a beep will be heard.
•When the connection is established, move the parent unit to the room you want to monitor from, but within the operational range.
•When there is no connection or out of range, the parent unit emits a warning beep every 3 seconds and the green link LED on the parent unit will flash.
•Move the parent unit closer until the link is
10 | Getting started |
|
|