Getting started, Baby unit battery Installation

2. Getting started

2.1Baby unit battery Installation

The baby unit can be used either with 3 AA size batteries (non- rechargeable batteries recommended) or the household AC mains. The baby unit has no charging function!

ENGLISH

	-	+	-		+	-
			1xAA	-
90° MAX	1	AAx1
90° MAX	x	AAx1
	A
	A
				1	AA	1 x
	+			x	AA	1 x
		-	+	AA	1x	AA
				AA

IMPORTANT

The non-rechargeable batteries for the Baby unit are not supplied with your product. We recommend the batteries to be installed before use, so that the unit continues to work in the event of a mains power failure.

1.Using a screwdriver, turn the screw of the battery cover on the back of the baby unit 90 degrees in a counterclockwise direction. Remove

the battery cover.

NOTE

Do not try to rotate the screw further than the position OPEN.

2.Install 3 AA non-rechargeable batteries following the polarity as shown.

3.Close the battery compartment and turn the screw 90 degrees back in a clockwise direction.

4.Press P. The power LED will illuminate.

5.Press and hold Pto switch off the baby unit.

NOTE

When the battery level is low, the power LED flashes.

WARNING

Do not mix old batteries with new ones. Keep batteries away from small children.

Do not short-circuit batteries or dispose of in fire.

Remove the batteries if this device is not going to be used for a long period of time.

Getting started	7