Cardo Q2 Reset Intercom Pairing, Make sure that both headsets are now flashing slowly in Blue

PRIMARY BUDDY PAIRING (requires two SCALA RIDER Q2 headsets)

1.If either headset is turned OFF, turn it ON by pressing and holding the CTRL Button until the Blue Light flashes three times.

2.Make sure that both headsets are now flashing slowly in Blue.

3.Pick up one headset and simultaneously press and hold the CTRL Button and MC Button for at least six seconds until the Red Light begins flashing rapidly, indicating it is in Intercom Pairing mode.

4.Repeat Step 3 again for the second SCALA RIDER Q2 headset. Both headsets should now be flashing rapidly in Red.

5.Within a few seconds, both headsets will show a solid Red light for two seconds, and then begin flashing slowly in Blue.

SECONDARY BUDDY PAIRING (requires three SCALA RIDER Q2 headsets)

In addition to the Primary Buddy pairing between the two units in your retail box you can pair your headset with the Secondary Buddy headset by repeating the above pairing procedure.

NOTE: Your headset can communicate with either the Primary Buddy or the Secondary Buddy. However, neither

the Primary Buddy nor the Secondary Buddy can communicate among each other directly via Intercom.

NOTE: If the Pairing process is not completed within one minute the headset will return to Standby mode.

SCALA RIDER® Q2™ MultiSet

STEP 2 (Optional)

SET UP FOR RIDER-TO-PASSENGER INTERCOM: PAIRING

There are two ways that the SCALA RIDER Q2 can be used for Rider- to-Passenger communication.

A. Both Rider and Passenger are using SCALA RIDER Q2 headsets (like the two units in your retail package).

To Pair the two headsets, follow the Steps listed in the section above titled PRIMARY BUDDY PAIRING.

B. The Rider is using a SCALA RIDER Q2 and the Passenger is using a SCALA RIDER headset (i.e. a SCALA RIDER Solo, a SCALA RIDER FM or a SCALA RIDER TeamSet Driver unit headset).

To Pair the two headsets:

1.Starting with the SCALA RIDER headset turned OFF, press and hold the CTRL button until the Red/Blue lights begin rapidly alternating.

2.Starting with the SCALA RIDER Q2 turned ON, simultaneously press and hold the CTRL Button and MC Button for six seconds until the Red light begins flashing rapidly, indicating it is in Intercom Pairing mode.

3.Within a few seconds, the SCALA RIDER Q2 will show a solid Red light for two seconds, and then begin flashing slowly in Blue.

NOTE: If the Pairing process is not completed within one minute the headset will return to Standby mode.

NOTE: When using a SCALA RIDER headset as a Passenger headset, Voice Connect Intercom can be initiated only by the SCALA RIDER Q2 headset. Manual Connect Intercom can be initi- ated from either headset by pressing the MC button for SCALA RIDER Q2 and CTRL button for other SCALA RIDER headsets.

RESET INTERCOM PAIRING

You can delete all of the headset’s Intercom pairings at any time.

English