Nortel Networks IP Phone 1100 Installing the expansion module, Installing an expansion module

Page 21

21

Chapter 3

Installing the expansion module

Complete the procedures in this chapter to install the expansion module for IP Phone 1100 Series phones. You must have an IP Phone 1120E and IP Phone 1140E in order to use an Expansion Module 1100 Series.

Installing an expansion module

Caution: Damage to equipment

To avoid damaging the equipment, remove the power (PeE cable or local power) from the IP Phone before you connect the expansion module.

You need a Phillips head screwdriver to complete this procedure.

1Press the tilt lever to adjust the stand angle on the IP Phone. You can adjust the stand angle to maximum, instead of removing the stand.

Adjustable stand

2At the back of the IP Phone, remove the rubber plug from the AEM port.

3Place the connecting arm of the expansion module behind the IP Phone.

4Align the expansion module connection plug with the AEM port on the back of the IP Phone.

5Insert the screws into the holes a the top and bottom of the connecting arm of the expansion module.

6Tighten the screws until they are snug.

Expansion Module 1100 Series User Guide

Image 21

Contents Expansion Module for IP Phone 1100 Series User Guide Copyright Nortel Networks 2007, All rights reserved Task List Task List NN40050-118 Contents Contents NN40050-118 Regulatory and safety information EMC compliance OtherRegulatory and safety information EMC compliance AS/NZS DenAn regulatory notice for Japan Regulatory and safety information NN40050-118 Getting Help from the Nortel Web site How to get helpHow to get help NN40050-118 About this guide Getting startedAudience AcronymsRelated publications Symbols and conventions used in this guideIntroduction Expansion module overviewWall mounting IP Phone 1140E with expansion module DisplayControls and settings Setup and assemblyServices key Shift/Outbox keyFull Contrast Display Diagnostics menuInstalling an expansion module Installing the expansion moduleInstalling a second or third expansion module Mounting the expansion module and phone on a wall Adjusting the tilt baseInstalling the expansion module NN40050-118 Initializing the expansion module Expansion module startup initializationExpansion module startup initialization NN40050-118 Making a call using a line key Using the handsetMaking a call using the speakerphone key Putting a call on holdProgramming a feature Programming indicator keysErasing a programmed indicator keys Programming external autodial