Nortel Networks 1100 Series manual Connecting the Expansion Module

Page 13

Setup and assembly

Figure 3: Connecting the Expansion Module

4.If connecting a second, or a third Expansion Module, repeat steps 2 to 4.

Note: The second Expansion Module is attached to the right side of the first Expansion Module. The third Expansion Module is attached to the right side of the second Expansion Module.

5.Adjust the height of the IP Phone tilt adjustment to a comfortable viewing angle. Then adjust each of the Expansion Module foot stands so they are flush to the desk surface. Turn the wheel on the back right side of the Expansion Module to the right (if viewed from the front) to tighten the Expansion Module.

WARNING

Do not over tighten the wheel on the Expansion Module.

6.Connect power to the IP Phone. The Expansion Module powers up.

Note: The Expansion Module uses the electrical connection of the IP Phone for power. It does not have its own power source.

Image 13

Contents Expansion Module for IP Phone 1100 Series Page Revision history Revision history Contents Contents Description About the Expansion Module for IP Phone 1100 SeriesIP Phone 1140E with Expansion Module FeaturesAdjusting the display Setup and assembly Damage to Equipment Installing the Expansion ModuleAdjusting the stand angle on the IP Phone Connecting the Expansion Module Expansion Module startup initialization Using the wall-mount optionAdjusting the tilt base Services key operation Controls and settingsShift key functionality Display diagnostics Controls and settings Regulatory and safety information Jurisdiction Standard Description OtherDenAn regulatory notice for Japan Regulatory and safety information Terms you should know Terms you should know Index Index Page Nortel Communication Server