Nortel Networks 1100 Series manual Adjusting the tilt base

Page 15

Setup and assembly

Adjusting the tilt base

The Expansion Module stand provides a continuous tilt adjustment so the tilt angle matches the IP Phone stand angle while accommodating variations in the desk surface. A clamp mechanism is used to unlock and lock the foot stand angle.

CAUTION

Do not over tighten the wheel on the Expansion Module.

The Expansion Module is tightened by spinning the wheel clockwise and loosened by spinning the wheel counter-clockwise.

Turn the wheel on the back right side (if viewed from the front) of the Expansion Module to loosen the stand hinge. Adjust the angle of the IP Phone using the tilt lever. When the IP Phone is set to a preferred angle, turn the wheel on the back of the Expansion Module to tighten the stand hinge and lock the stand at the same angle as the attached IP Phone.

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Expansion Module for IP Phone 1100 Series Page Revision history Revision history Contents Contents Description About the Expansion Module for IP Phone 1100 SeriesIP Phone 1140E with Expansion Module FeaturesAdjusting the display Setup and assembly Damage to Equipment Installing the Expansion ModuleAdjusting the stand angle on the IP Phone Connecting the Expansion Module Expansion Module startup initialization Using the wall-mount optionAdjusting the tilt base Controls and settings Services key operationShift key functionality Display diagnostics Controls and settings Regulatory and safety information Jurisdiction Standard Description OtherDenAn regulatory notice for Japan Regulatory and safety information Terms you should know Terms you should know Index Index Page Nortel Communication Server
Top Page Image Contents