Nortel Networks 1100 Series manual Installing the Expansion Module, Damage to Equipment

Page 11

Setup and assembly

Installing the Expansion Module

Use the following instructions to install the Expansion Module.

CAUTION

Damage to Equipment

To avoid damaging the equipment, remove the power (PoE cable, or local power) from the IP Phone before connecting the Expansion Module.

CAUTION

Damage to Equipment

The Expansion Module is shipped with the base locked in position. To avoid damaging the Expansion Module, press the tilt lever, located on the base at the front of the Expansion

Module.

Wall Mount Lever

1.Press the tilt lever to adjust the stand angle on the IP Phone. You can adjust the stand angle to maximum, instead of removing the stand. See Figure 2.

11

Image 11

Contents Expansion Module for IP Phone 1100 Series Page Revision history Revision history Contents Contents Description About the Expansion Module for IP Phone 1100 SeriesIP Phone 1140E with Expansion Module FeaturesAdjusting the display Setup and assembly Damage to Equipment Installing the Expansion ModuleAdjusting the stand angle on the IP Phone Connecting the Expansion Module Expansion Module startup initialization Using the wall-mount optionAdjusting the tilt base Shift key functionality Controls and settingsServices key operation Display diagnostics Controls and settings Regulatory and safety information Jurisdiction Standard Description OtherDenAn regulatory notice for Japan Regulatory and safety information Terms you should know Terms you should know Index Index Page Nortel Communication Server