NEC DTR-IR-2 user manual Install the Rechargeable Battery Pack into the Handset

Page 10

B. Install the Rechargeable Battery Pack into the Handset

The handset is powered by a rechargeable battery pack. The battery recharges automatically when the handset is placed in the base unit. To maximize the charge capacity of your battery pack, DO NOT plug the telephone cord into the base unit and wall jack until the battery is fully charged.

1)Press down on the handset battery case cover (use the finger indention for a better grip) and slide the cover downward to remove.

2)Turn the battery pack so that the connector with the red and black wires is near the jack inside the battery compartment. Match the connector's wire colors to the polarity label in the battery compartment (the connector notches fit into the grooves of the jack only one way). Push the battery pack connector into the jack until it clicks into place.

3)Make sure you have a good connection by gently pulling on the battery wires. If the connection is secure, the battery jack will remain in place.

4)Place the battery case cover back on the handset and slide it upwards until it clicks into place.

note	•	Use only the NEC rechargeable battery pack supplied with your cordless telephone.
note	•	Replacement battery packs are also available. Contact your NEC Representative.

[ 6 ]

G e t t i n g S t a r t e d

Image 10

Contents Dterm Analog Cordless Page Table of Contents Precautions and Warranty Welcome Welcome/Features/TerminologyFeatures TerminologyControls & Functions DC in 9V Jack TEL Line JackDisplays and Icons Animation DisplaysSoft Key Function Getting Started Setting up the PhoneChoose the best location Install the Rechargeable Battery Pack into the Handset Connect the Base Unit Standard Wall Plate Mounting Mounting the Base Unit on a WallDirect Wall Mounting Connecting the Charger Register the HandsetUsing the interface Setting Menu OptionsDefault Settings Main Menu OptionsHandset Setup Programming your Voice Mail Access NumberPress /vol/∧ or /vol/∨ to select O n or Of f Global Setup Setting Day and TimeThis page Intentionally Left Blank Basics Making and Receiving CallsAdjusting the Ringer, and Earpiece and Speaker Volume Redialing a CallTemporarily Muting the Ringer Tone Dialing Switch-overPrivacy Mode Mute MicrophoneThis page Intentionally Left Blank Phonebook Store/Edit No . appearsChain Dialing Steps for Entering Names and Special CharactersViewing the Phonebook If You Make a Mistake while Entering a NameFrom Talk Mode Making Calls Using the PhonebookFrom Standby Mode Speed DialingDeleting a Caller ID Message Caller IDViewing the Caller ID List Deleting Information from the Caller ID ListUsing the Caller ID Message List Calling a Party from the Caller ID ListAdditional Information Installing the BeltclipHeadset Installation Changing the Digital Security CodePower Failure Battery Replacement and HandlingLow Battery Alert Replacement Item Part Numbers Cleaning the Battery Charging ContactsBattery Information General InformationThis page Intentionally Left Blank Troubleshooting Charge LED wont illuminateLiquid Damage HandsetPrecautions and Warranty PrecautionsInstallation Considerations Terminal Equipment Radio EquipmentThis page Intentionally Left Blank Memory List Memory ListD i t i o n a l I n f o r m a t i o n Flow Chart Main Menu Flow ChartT t i n g S t a r t e d Page Dterm Analog Cordless