NEC DTR-IR-2 user manual Additional Information, Changing the Digital Security Code, Find Handset

Page 29

Additional Information

Changing the Digital Security Code

The digital security code is an identification code used to connect the handset and the base unit. Normally, setting the code is not necessary. In the rare situation that you suspect another cordless telephone is using the same security code, you can change the code. To change the digital security code:

1De-register the handset (see “Deregister the handset“ on page 13).

2Register the handset by following step 2-3 in “Registering the handset“ on page 9.

Find Handset

To locate the handset, press find handset on the base when the phone is in standby mode. All registered handsets beep for 60 seconds, and Pa gi n g appears on the handset display. To cancel paging, press any key on the handset or find handset on the base..

If the battery pack is completely drained, the handset will not beep when paging.

note

Installing the Beltclip

To Attach the Beltclip

Insert the beltclip into the holes on each side of the handset. Press down until it clicks

To Remove the Beltclip

Pull either side of the beltclip to release the tabs from the holes.

Headset Installation

Your phone can be used with an optional headset. To use this feature, insert the headset plug into the headset jack. Your phone is ready for hands-free conversations. (Headset can be purchased by calling your local NEC Representative.)

ADDITIONAL INFORMATION

B a s i c s

[ 2 5 ]

Image 29
Contents Dterm Analog Cordless Page Table of Contents Precautions and Warranty Features Welcome/Features/TerminologyWelcome TerminologyDC in 9V Jack TEL Line Jack Controls & FunctionsAnimation Displays Displays and IconsSoft Key Function Choose the best location Setting up the PhoneGetting Started Install the Rechargeable Battery Pack into the Handset Connect the Base Unit Direct Wall Mounting Mounting the Base Unit on a WallStandard Wall Plate Mounting Register the Handset Connecting the ChargerDefault Settings Setting Menu OptionsUsing the interface Main Menu OptionsProgramming your Voice Mail Access Number Handset SetupPress /vol/∧ or /vol/∨ to select O n or Of f Setting Day and Time Global SetupThis page Intentionally Left Blank Making and Receiving Calls BasicsRedialing a Call Adjusting the Ringer, and Earpiece and Speaker VolumePrivacy Mode Tone Dialing Switch-overTemporarily Muting the Ringer Mute MicrophoneThis page Intentionally Left Blank Store/Edit No . appears PhonebookSteps for Entering Names and Special Characters Chain DialingIf You Make a Mistake while Entering a Name Viewing the PhonebookFrom Standby Mode Making Calls Using the PhonebookFrom Talk Mode Speed DialingViewing the Caller ID List Caller IDDeleting a Caller ID Message Deleting Information from the Caller ID ListCalling a Party from the Caller ID List Using the Caller ID Message ListHeadset Installation Installing the BeltclipAdditional Information Changing the Digital Security CodeLow Battery Alert Battery Replacement and HandlingPower Failure Battery Information Cleaning the Battery Charging ContactsReplacement Item Part Numbers General InformationThis page Intentionally Left Blank Charge LED wont illuminate TroubleshootingHandset Liquid DamagePrecautions Precautions and WarrantyInstallation Considerations Radio Equipment Terminal EquipmentThis page Intentionally Left Blank Memory List Memory ListD i t i o n a l I n f o r m a t i o n Main Menu Flow Chart Flow ChartT t i n g S t a r t e d Page Dterm Analog Cordless