NEC DTR-IR-2 user manual Liquid Damage, Handset

Page 34

Liquid Damage

Moisture and liquid can damage your cordless phone. In case of accidental submersion, please read the following steps.

	Case		Action

	If the handset or base is exposed
	to moisture or liquid, but only	Wipe off the liquid, and use as normal.
	affects the exterior plastic	Wipe off the liquid, and use as normal.
	affects the exterior plastic
	housing.

	If moisture or liquid has entered	Handset:
	the plastic-housing (i.e. liquid can	1	Remove the battery cover and leave it off for ventilation.
	be heard in the phone or liquid	2	Remove the battery pack by disconnecting.
	has entered the handset battery	3	Leave the battery cover off and the battery pack disconnected for at
	compartment or vent openings on		least 3 days.
	the base).	4	Once the handset is completely dry, reconnect the battery pack and the
			battery cover.
		5	Recharge the handset's battery pack for 20 hours before using again.
		Base:
		1	Disconnect the AC adapter from the base unit, cutting off electrical
			power.
		2	Disconnect the telephone cord from the base unit.
		3	Let dry for at least 3 days.
		IMPORTANT:
		You must unplug the telephone line while recharging the battery pack
		to avoid charge interruption.
		CAUTION:
		DO NOT use a microwave oven to speed up the drying process. This will
		cause permanent damage to the handset, base and the microwave oven.
		After following these steps, if your cordless telephone does not work, please
		contact your local NEC Representative.

[ 3 0 ]

T r o u b l e s h o o t i n g

Image 34

Contents Dterm Analog Cordless Page Table of Contents Precautions and Warranty Welcome Welcome/Features/TerminologyFeatures TerminologyControls & Functions DC in 9V Jack TEL Line JackDisplays and Icons Animation DisplaysSoft Key Function Getting Started Setting up the PhoneChoose the best location Install the Rechargeable Battery Pack into the Handset Connect the Base Unit Standard Wall Plate Mounting Mounting the Base Unit on a WallDirect Wall Mounting Connecting the Charger Register the HandsetUsing the interface Setting Menu OptionsDefault Settings Main Menu OptionsHandset Setup Programming your Voice Mail Access NumberPress /vol/∧ or /vol/∨ to select O n or Of f Global Setup Setting Day and TimeThis page Intentionally Left Blank Basics Making and Receiving CallsAdjusting the Ringer, and Earpiece and Speaker Volume Redialing a CallTemporarily Muting the Ringer Tone Dialing Switch-overPrivacy Mode Mute MicrophoneThis page Intentionally Left Blank Phonebook Store/Edit No . appearsChain Dialing Steps for Entering Names and Special CharactersViewing the Phonebook If You Make a Mistake while Entering a NameFrom Talk Mode Making Calls Using the PhonebookFrom Standby Mode Speed DialingDeleting a Caller ID Message Caller IDViewing the Caller ID List Deleting Information from the Caller ID ListUsing the Caller ID Message List Calling a Party from the Caller ID ListAdditional Information Installing the BeltclipHeadset Installation Changing the Digital Security CodePower Failure Battery Replacement and HandlingLow Battery Alert Replacement Item Part Numbers Cleaning the Battery Charging ContactsBattery Information General InformationThis page Intentionally Left Blank Troubleshooting Charge LED wont illuminateLiquid Damage HandsetPrecautions and Warranty PrecautionsInstallation Considerations Terminal Equipment Radio EquipmentThis page Intentionally Left Blank Memory List Memory ListD i t i o n a l I n f o r m a t i o n Flow Chart Main Menu Flow ChartT t i n g S t a r t e d Page Dterm Analog Cordless