AT&T AS45 user manual Turn System Off, Turn System On, Memory Full

Page 7

R E M O T E O P E R A T I O N

Turn System Off

Press 00.

Turn System On

When the system is off, it answers after 10 rings, announces “The machine is off,” and beeps twice.

1Press 0to turn the system on.

2The system beeps twice and is ready to answer calls and record messages. If the system beeps five times, the memory is full.

Memory Full

The system answers after 10 rings, then announces “Memory is full,” and beeps twice, you must delete messages to make room for new ones.

1Enter the Remote Access Code after two-beep signal.

2Listen to messages, and delete some or all of them.

3Press 0to make sure your system is on before you hang up.

6

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Revised 1/18/99 TEL Line InstallationRecording Your Announcement Setting the ClockVolume Control E R a T I O NMessage Window Feature Set UpRemote Access Code Answering CallsSaving Messages When Memory is FullAnnouncement Monitor Listening to Your MessagesM O T E O P E R a T I O N Turn System On Turn System OffMemory Full Message Window Is Blank C a S E O F D I F F I C U LT YRevised 1/15/99 ONE KEY Remote Commands Installation E R a T I O N AS45 map1ATT 18/99, 226 PM
Top Page Image Contents