AT&T 1817 user manual Power Failure Recovery, Message Window Displays

Page 6

I N C A S E O F D I F F I C U LT Y

Power Failure Recovery

If the system is disconnected from AC power, the answering system will not operate, but you will still be able to make and receive calls. Your announcement and messages are retained in memory during a power failure, but you will need to reset the clock when power is restored. See the instructions on the bottom of the unit.

Message Window Displays

Clock needs to be reset.

Flashing – System is busy or in use

— OR —

Steady – System in Remote Access mode.

Remote listening mode.

Deleting (rotating).

Memory is full

— OR —

Announcement monitor is off (shown during Setup).

Call 1 800 222–3111.

5

Image 6
Contents Tapeless Digital Answering System Telephone with Time/Day Set Dial Mode Table/Desk InstallationConnect the short line cord to the telephone Wall InstallationFollow Steps 5-7 under Table/Desk Installation Reverse the handset tabRedial Ringer VolumeReceiver Handset Volume FlashTelephone Does Not Ring System Does Not Respond To Remote CommandsNo Dial Tone Message Window Is BlankPower Failure Recovery Message Window DisplaysSetting the Clock Recording Your AnnouncementTurning the System On/Off Volume ControlFeature Set Up Answering CallsListening to Your Messages Remote Access CodeAnnouncement Monitor Saving MessagesRecording a Memo When Memory is FullDeleting Messages Delete All messagesPlaying Messages Ending the Remote Access CallConnect with Answering System Record AnnouncementTurn System Off Turn System OnMemory Full Tapeless Digital Answering System TWO KEY Remote Commands