Panasonic SH-MZ1200 Mixing Basic operations, Turn L/R Split CH1 CH2 and L/R Split CH3 CH4 to OFF

Mixing (Basic operations)

L L/R SPLIT R

Press [POWER OFF ON]

The POWER lamp comes on after the power is turned on.

1 Turn [L/R SPLIT (CH1 CH2)] and [L/R SPLIT (CH3 CH4)] to OFF

Select CH1 or CH2 input, CH3 or CH4 input to use the PLAY MODE's (L) and (R) individual adjustment feature ( page 12).

2 Switch [SEPARATE OUT] to OFF

Turn on to activate the play mode SEPARATE OUT function ( page 12).

Using CH1 input

3 Switch the input switch (CD/LINE DIGITAL, LINE) to select the source

When you select CD/LINE DIGITAL on CH1 or CH4, input can be analog input (CD/LINE CH1, CH4 input terminal) or digital input (DIGITAL IN CH1, CH4 input terminal).

4 Turn [TRIM], [HIGH], [MID] and [LOW] to adjust the input signal level and sound

TRIM:

Adjusts the input signal level.

Turn to the right for higher sound level (to approximately +8 dB) Turn to the left for lower sound level (to approximately –8 dB)

HIGH:

Adjusts the high tone input sounds. Sound is flat at the center position.

Turn to the right to increase sound (to approximately +12 dB at 10 kHz) Turn to the left to decrease sound (to approximately –24 dB at 10 kHz)

MID:

Adjusts the mid tone input sounds. Sound is flat at the center position.

Turn to the right to increase sound (to approximately +12 dB at 1 kHz) Turn to the left to decrease sound (to approximately –24 dB at 1 kHz)

LOW:

Adjusts the low tone input sounds. Sound is flat at the center position.

Turn to the right to increase sound (to approximately +12 dB at 50 Hz) Turn to the left to decrease sound (to approximately –24 dB at 50 Hz)

5 Use the channel fader to adjust the volume

Select the CH2-CH4 source and adjust volume and sound

(Same as instructions 3 - 5 indicated on the left)

6 When using the cross fader

Turn [ASSIGN A] and [ASSIGN B] to select the input channel to assign and

•Select different input channels using the ASSIGN A and ASSIGN B switches.

If the same input channel is selected by both switches, the volume will remain unchanged even when the cross fader is operated.

•The channel selected with ASSIGN A is assigned to , the channel selected with ASSIGN B is assigned to . Unassigned channels are not output through the cross fader. 1-4:Assigned channels 1 to 4

THRU: When not using the cross fader

7 When using the cross fader

Use [CROSS FADER] to adjust the mixing level

The mixing level of the source audio assigned to and is adjusted by varying the position of the cross fader.

8 Turn [MASTER LEVEL] and [MASTER BALANCE] to adjust the volume and balance

Adjust the master output volume and left (L) and right (R) balance.

•Input source audio from the selected channels CH1-CH4 is mixed and output through the MASTER OUT 1 left (L) and

(R) terminals.

•Even if the MASTER LEVEL or the MASTER BALANCE is changed the REC OUT or DIGITAL OUT output does not change.

9

RQT7230