Connecting the Headsets, Starset* Headpiece

Connecting the Headsets

The CALLMASTER VI provides two 4-pin headset jacks. The following Lucent headsets are compatible with the CALLMASTER VI:

●Starset* Headpiece

●Supra* Headpiece

●Mirage* Headpiece

●TriStar† Headpiece

●Encore † Headpiece

The two headset jacks share the same volume setting. The headset jacks are not labeled; they are located near the bottom front of the unit on the right and left sides. See Figure 5 for an example of the headset jack connections.

1.4-Pin Connector

2.Quick Disconnect

Figure 5: Connecting the Headset Jacks

To connect the headset, do the following steps:

1.Insert the 4-pin male connector end of the headset adapter cord into the headset jack on either the right or left side of the

CALLMASTER VI.

2.Insert the quick disconnect end of the headset adapter cord into the headset.

A handset with a custom cable will work if plugged into one of the headset jacks. The handset is available as a D-Kit.

*Registered trademarks of Plantronics, Inc. †Trademarks of Plantronics, Inc.