Testing the Headset
To test the headset, do the following steps:
1. Connect the headset to the CALLMASTER VI.
2 . Press the Headset On/Off button, and listen for the dial tone. If you do not hear the dial tone, press a Call Appearance button.
If you still do not hear a dial tone, check that the cord is securely connected to both the jack and to the headset.
It is recommended that you do not remove the headset adaptor cord from the CALLMASTER VI unless it becomes necessary to replace the cord. Disconnect the headset at the quick disconnect point on the headset cord, not at the CALLMASTER VI jack.
Designation Strips
You receive the following designation strips with the CALLMASTER VI:
●The first has English descriptions of three buttons (Headset On/ Off, Mute, and Release) and the Message indicator.
●The second strip was designed for international applications. It has no descriptions but has the CALLMASTER VI name and Lucent logo. You would use it to describe buttons in languages other than English. You can also use it if you do not want button descriptions, or if the blue button is not administered for the Release function.
●The third strip is blank for custom applications.
A transparent cover holds the designation strip in position on the CALLMASTER VI voice terminal.
To insert the designation strip, do the following steps:
1.Remove the transparent cover by pulling the bottom edge of the cover toward you.
2.Put the designation strip in place.
3.Replace the cover by hooking it over the top edge of the CALLMASTER VI voice terminal and snapping it in place over the bottom edge.
The transparent cover is attached to the frame of the voice terminal by tabs on the top and bottom of the cover.
9