Bizfon WD482400400 manual User Guide BizTouch IP2, Regulatory Notices

Page 2

User Guide – BizTouch™ IP2

Regulatory Notices

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

∙Reorient or relocate the receiving antenna.

∙Increase the separation between the equipment and the receiver.

∙Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

∙Consult the dealer or an experienced radio/TV technician for help.

You may also find helpful the following booklet, prepared by the FCC: "How to Identify and Resolve Radio-TV Interference Problems." This booklet is available from the U.S. Government Printing Office, Washington D.C. 20402.

Changes and Modification not expressly approved by the manufacturer or registrant of this equipment can void your authority to operate this equipment under Federal Communications Commissions rules.

The Power Supply is a plug-in Class 2 transformer. It is model no. WD482400400. Input voltage is 120VAC, 60Hz 16W. Output voltage is 24VDC 400mA. UL listed. The product was made in China.

This product adheres to the IEEE 802.3af standard for Power over Ethernet (PoE).

Page 1 Page 3
Image 2
Page 1 Page 3
Contents User Guide BizTouch IP2 User Guide BizTouch IP2 Regulatory NoticesTable of Contents Advanced Topics Getting Started What is in the box?Connecting the Phone BizTouch IP2 Introduction to Your Biztouch IP2Definitions User Guide BizTouch IP2 Using the Buttons BizTouch IP2Transfer a call Place a callVoice Mail Place aVoice Mail Release ButtonInfo Button Mute a CallPlace a Call on Hold Park a Call PBX ModePark a Call Key System Mode Prevent Incoming Calls Do Not DisturbSpeakerphone Placing and Splitting a Conference CallSpeed Dial IntercomJoining a Queue HeadsetAnswering a Call in the Queue Leaving a QueuePlacing a Call Answering a Call When You are on the PhonePBX Behavior Answering a CallIgnore and Silence Softkeys Redial a NumberMissed Calls KEY System BehaviorUser Guide BizTouch IP2 Change the Labels for Lines Adjust the Angle of the Phone Adjusting Your PhoneVolume Adjust the Contrast of the ScreenChanging Preferences Config MenuAdvanced Topics Highlight Reboot Phone Reboot the PhoneCheck the Network Settings Clear Call HistoryCheck the Current Status Check StatisticsSave Changes to Your Settings Reset the Phone to Its Factory DefaultsWall Mounting Your Phone Optional Standard Telephone Wall Mounting Plate
Top Page Image Contents