Bogen UTI1 specifications Override Input

Page 10

Override Input

The Override is a non-programmable feature that lets the caller take priority over all paging functions and make a page to all speakers.The feature can be activated using a loop start trunk or dedicated telephone.

The center two conductors interface directly to a Loop Start Trunk or a dedicated phone.When the trunk becomes active, the UTI1 goes into Override mode.A contact closure and dry audio source can also be used for the Override Input. The two conductors flanking the talk battery conductors provide a dry audio gateway into the system override. Override is activated by shorting the outermost conductors.

Maximum contact closure resistance is 1000 ohms. Open collector type outputs for controlling a page may also be used.The Override feature includes a quad beep pre-announce tone that can be enabled or inhibited. (The default is inhibited.)

Make sure that the power is disconnected and all other connections are completed before proceeding. Plug modular cord into OVERRIDE (RJ11) jack.

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Universal Telephone Interface UTI1 Model FCC Statement Part 15 Radio Frequency Interference Contents UTI1 Feature Callouts Introduction Installation Wall MountingTrunk Disconnect Telephone Interface Wiring Connections & SetupTelephone System Connections PBX Loop Start Trunk PortPBX Ground Start Trunk Port PBX Page Port ContactPBX Page Port VOX PBX Analog Station PortOverride Input Other Connections Controls Tones ReferenceReset Default Values Default TimerVOX Timer System ProgrammingEvent Enable/Disable AUX Relay ContactExample Feature Codes & Defaults Dtmf BlockSpecifications Block Diagram Limited Warranty
Top Page Image Contents