Panasonic SC-NE3 Software update Wireless network name Ssid, Checking the software version

Software update Wireless network name (SSID)

Occasionally, Panasonic may release updated software for this unit that may add or improve the way a feature operates. These updates are available free of charge.

Preparation

≥Turn the unit on.

≥Connect this unit to the wireless network. (l 7)

–Make sure that the wireless network is connected to the Internet.

–If “D.CONNECT” is set to “ON”, change the setting to “OFF” and connect this unit to a wireless network that is connected to the Internet.

1 Press [SETUP] repeatedly to select “SW UPDATE” and then press [OK].

2 Press [3, 4] to select “UPDATE? Y” and then press [OK] to start the update.

DO NOT DISCONNECT the AC power supply cord while one of the following messages is displayed.

–“LINKING”, “UPDATING” or “%” (“ ” stands for a number.)

≥During the update process, no other operations can be performed.

3 When the update has finished successfully, “SUCCESS” is displayed.

4 Disconnect the AC power supply cord and reconnect it after 3 minutes.

≥Downloading will require several minutes. It may take longer or may not work properly depending on the connection environment.

≥If you do not want to update the unit, select “UPDATE? N” and then press [OK] in step 2.

≥If there are no updates, “NO NEED” is displayed after step 2.

∫Checking the software version

1Press [SETUP] repeatedly to select “SW VER.” and then press [OK].

{. The version of the installed software is displayed.

2Press [OK] to exit.

14

Display the name for the connected wireless network (SSID).

1 Press and hold [– WPS] on the unit and [OK] on the remote control until the unit's display shows the SSID.

2 Press [OK] to exit.

≥If “NOCONNECT” is displayed this unit is not connected to a wireless network.

≥All letters are displayed as capital letters, and characters that cannot be displayed are replaced with “¢”.

IP/MAC Address

To check the unit’s IP address or the Wi-Fi MAC address.

1 Press and hold [– WPS] on the unit and [4] on the remote control until the unit’s display shows the IP address.

{.The IP address is partially displayed.

≥To display the MAC address on the unit, repeat the steps above by replacing [4] with [3].

2 Press [3, 4] on the remote control to show the rest of the IP address.

≥To exit the setting, wait 20 sec.

≥The “ – ” displayed on the top or bottom left of the display indicate the first and last units respectively.

Changing the unit and remote control code

When other Panasonic equipment responds to the supplied remote control, change the remote control code.

1	Press [ , AUX] to select “AUX”.
2	While pressing and holding [ / AUX] on the
	unit, press and hold [SOUND] on the remote
	control until the unit’s display shows
3	“REMOTE 2”.
	Press and hold [OK] and [SOUND] on the

remote control for at least 4 seconds.

≥To change the mode back to “REMOTE 1”, repeat the steps above but replace the button pressed on the remote control from [SOUND] to [ , AUX].

VQT4U49