FCC Regulations
Pertaining to this equipment
Interference Information (Part 15) Some telephone equipment generates and uses radio frequency energy, and if not installed and used properly, may cause interference to radio and television reception.
Your Lucent Technologies product has been tested and found to meet the standards for a Class B computing device, as specified in Subpart J of Part 15 of the FCC Rules. These specifications are designed to provide protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation.
If your Lucent Technologies product causes interference to radio or television reception when in use, you might correct the interference with any one or all of these measures:
1Where it can be done safely, reorient the receiving television or radio antenna.
2To the extent possible, relocate the television, radio, or other receiver with respect to the telephone equipment.
3If your telephone product runs on AC power, plug your product into an AC outlet that’s not on the same circuit as one used by your radio or television.
Registration Information (Part 68) The following information is applicable only to equipment connected directly to the telephone network and not to connection of stations behind terminal systems.
In compliance with the FCC Rules, you should be aware of the following:
1Connection of this equipment to the telephone network must be through one of the standard network interface jacks. These jacks may be ordered from the local telephone company or through Lucent Technologies as your authorized agent.
2Registered equipment may not be used with coin telephone lines or party lines.
3Customers connecting equipment to the telephone network will, upon request of the local telephone company, provide the following information: