IV. Phone Calls, How to dial out? | ArtDio IPF-3000 manual

(4)Press 【SPK】 to exit the configuration menu and the system will try to register to those activated SIP domains. The flashing green LED of 【Registration】key indicates that the registration is undergoing. Once the green LED stops flashing, you could know the registration result by the LED:

Green LED On: Successfully register to all active service domains.

Red LED On: At least one service domain could not be registered.

Green LED Flashes: Registration is in progress.

Red LED Flashes: No service domains have ever registered successfully.

Or press【Service Realm】to show registration status of each active service domain: 0 : a - v o i z ee . c o m

0 : f w d . p u l v e r . c o m

X : u n k n o w n . c o m

0: Registered domain

X: Registration failed domain (Retry after 90 seconds).

IV. Phone Calls

Press【SPK】to switch between hands-free and handset mode. However, if you switch to hands-free mode with handset lifted (off-hooked), the phone will be in loud-speaker mode: it continues transmitting voice from handset, not from microphone, and played voice to both speaker and handset receiver simultaneously. It will help clarify the voice of talker while letting all persons in the same room listen. The phone will activate microphone for voice transmission only when it is on hands-free mode and the handset is on hook. This applies to ear-phone mode as well. In loud speaker mode with ear-phone enabled, the ear-phone could hear voice but not speak-able.

1.How to dial out?

fw d . p u l v e r . c o m 3 2 0 0

a-voize.com

fwd.pulver.com

Auto-locate

By default, you can gain access to active Service-Domain-N by line-N whenever applicable. That is, the default service domain of [B call] is 2nd active service domain if available; otherwise, it will use the 1st active service domain as default.

Moreover, you could change the target service domain while making calls by pressing 【Service Realm】to circle those active service domains (no matter whether they have registered or not), but must before dialing the ‘#’, which finishes the dialing. The active service domain will appear on the upper-right corner.

Quick Installation Guide

-6-

IPF-3000