Table/Desk, Data Port, Headset Jack

I N S T A L L A T I O N

Table/Desk

1Connect line cord(s) to telephone.

•If you have a two-line jack, use only the line cord with the clear modular plugs on each end. Plug one end into the jack labeled L1 OR L1/L2 on the back of the telephone.

•If you have two separate jacks, use both line cords. Insert one end of the cord with the blue plugs into the jack labeled L1 OR L1/L2 on the back of the telephone. Insert one end of the cord with the clear plugs into the jack labeled L2 on the back of the telephone.

2Attach the base.

Turn the base so that the larger end of the base is toward the top of the telephone. Attach the base by inserting the tabs into the slots. Push down on the large end of the base to lock it into place.

3Connect the line cord(s) to your modular jack(s).

•If you have a two-line jack, plug the free end of the line cord into a modular telephone jack. Make sure the cord snaps firmly into place.

Two-line

Modular

Jack

Telephone Line Cord with clear modular plugs

•If you have two separate jacks, plug the free end of the cord with the blue plugs into the modular jack for Line 1. Plug the free end of the cord with the clear plugs into the modular telephone jack for Line 2. Make sure the cords snap firmly into place.

	Modular	Modular
	Jack for	Jack for
	Line 1	Line 2
	Telephone Line	Telephone Line Cord with
	Telephone Line	clear modular plugs
	Cord with blue	clear modular plugs
	Cord with blue
	modular plugs

4Connect handset to telephone.

5Set Dial Mode.

This product comes set for touch tone dialing. Make sure you choose the correct dialing method (TONE or PULSE); dial pulse dialing will not work if you have touch tone service.

To set for dial pulse (rotary) service, lift handset and press Lor l, then press P, #, #,

#, 3. To change back to touch tone service, press P, #, #, #, 8.

To switch from pulse to tone dialing during a phone call, see “Temporary Tone” under

TELEPHONE OPERATION.

6Check for dial tone.

Press L, lift the handset, press K or press h, and listen for a dial tone.

Then press l. If you cannot hear a dial tone, turn to IN CASE OF DIFFICULTY.

7Confirm Lines 1 and 2.

To determine which line is which, press L and call one of your telephone numbers. If you hear a busy signal, Line 1 is the number you called. If Line 2 rings, it is the number you called.

Data Port

If you want to connect another device (such as a modem or fax machine) to the wall jack, you can use the jack on the phone labeled DATA L2. The data port uses Line 2; a call picked up on Line 2 at another extension may interrupt a fax, modem, or message transmission.

Headset Jack

You can use this telephone hands-free when you install any AT&T 2.5 mm headset, purchased separately.

Plug the headset into the jack. Do not force the connection, but make sure the plug fits securely.