Wall, Or L1/L2 on, Reverse handset tab

I N S T A L L A T I O N

Wall

1Connect bundled line cord(s) to the telephone. Leave the telephone line cord(s) bundled.

•If you have a two-line wall jack, use only the line cord with the clear modular plugs on each end. Plug one end into the jack labeled L1 OR L2 on the back of the telephone. Place the bundled line cord in the open area under the set.

•If you have two separate wall jacks, use both line cords.

Leave the cord with the blue plugs bundled. Plug one

end of this cord into the jack labeled L1

OR L1/L2 on the

back of the telephone. Unbundle the cord

with the clear plugs. Plug one end of this cord into the jack labeled L2 on the back of the phone. Rebundle the cord and store it in the open area under the set.

2Attach the base.

Turn the base so that the larger end of the base is toward the bottom of the telephone. Attach the base by inserting the tabs into the slots.

Push down on the large end of the base to lock it into place.

3Reverse handset tab.

To mount the telephone on a wall, you must reverse the handset tab. This tab holds the handset when you hang up.

Hold down the switchhook, and slide the tab up and out of its slot. Turn the tab so that the curved end is up. Insert the tab back into its slot.

4Connect the line cord(s) to modular wall jack(s) and mount phone onto wall jack.

•If you have a two-line jack, plug the free end of the line cord into the modular wall jack. Make sure the cord snaps firmly into place. Place the phone on the wall jack mounting studs and pull down until it is held securely.

•If you have two separate jacks, plug the free end of the cord with the blue plugs into the jack for Line 1. Plug the free end of the cord with the clear plugs into the jack for Line 2. Make sure the cords snap firmly into place. Place the phone on the wall jack mounting studs and pull down until it is held firmly in place.

Follow Steps 4 through 7 under Table Installation.