Dolphin Peripherals DXS410 quick start Software Required, Hardware Installation Procedure

1.3 Software Required

The DXS410 DX Switch can be used in a number of applications. Dolphin provides specific application software to support these various applications. This software is nec- essary to use the DXS410. Application software can be downloaded from the Dolphin website at http://www.dolphinics.com/support/. Software installation instruction can be found on the Dolphin website.

1.4Hardware Installation Procedure

1.Remove the chassis from the box

2.Connect main power (100-240VAC) using the provided AC power cord or a region- ally appropriate AC power cord to the DXS410 power connector, which is located on the front of the chassis see Figure 1–1. The power supply will accept any voltage from 100V to 240VAC at frequency of 50-60Hz.

Figure 1–1 AC Power Inlet

3.Turn on the AC power switch on the front of the DXS410. This will apply AC power to the chassis.

4.The DXS410 switch will go through a self test. You will observe that for 0.5 sec- onds the 10 Port LEDs turn green and that the red alarm LED along with the green power LED turn on. Then for 0.5 seconds, the 10 Port LEDs turn yellow while the other 2 LEDs stay on. The 10 Port LEDs and the Alarm LED will then turn off while the power LED is kept on.

5.Insert one or more cables into the connectors on the front of the switch box. The connectors are labeled for x4 or x8 operation as show in Figure 1–2.

April 2008 Installation 2