957_book_2ATT ill at margins 11/16/00 1:39 PM Page 5
INSTALLATION
Standard | Modular |
electrical | telephone |
outlet | wall jack |
Power cord | Telephone |
| line cord |
6Connect the line cord to a modular jack.
7Connect the power cord to a standard electrical outlet not controlled by a wall switch.
NOTE: When you first plug in the power cord, the screen displays WHICH LANGUAGE?. Follow the programming steps on page 8 after installation is complete.
8Connect the handset to the telephone.
Plug the coiled cord into the handset jack on the side of the phone. Plug the other end of the coiled cord into the handset, then hang up.
9Check for dial tone.
Lift the handset and listen for a dial tone. If you cannot hear
a dial tone, press VOLUME +. If you still do not hear a dial tone, see the IN CASE OF DIFFICULTY section of this manual.
Your phone will work immediately after installation using the default feature settings (see “Feature Summary” on page 10).
NOTE: If you subscribe to Caller ID services from your local telephone service provider, you must follow the instructions in “Set Home Area Code” for your phone to properly recognize and dial calls (see page 8) . You may also need to “Set Local Area Codes” (see page 9).
5