AT&T 8434 manual Select Ring and Ringer Volume

Remember that you can use the Reset Speakerphone feature only if your voice terminal is set for the Speakerphone feature (as opposed to the Speaker feature).

To adjust the	1	Press [ Select ]
speakerphone to the		●	Green light next to [ Select ] goes on steadily
surrounding room
acoustics	2	Press [ Speaker Reset Spkr ]
		●	Green light next to [ Select	] goes off
		●	Green light next to [ Speaker Reset Spkr ] flutters
			intermittently
		● You hear a series of tones as the speakerphone
			performs an acoustic test of the environment.
			When the tones stop, your built-in speakerphone
			is ready for use.
Select Ring (and Ringer Volume)
					✔
To select a	1	While on-hook, press [ Select ]
personalized ring		●	Green light goes on steadily
	2	Press [ Conference Ring ]

To adjust the volume of the tone ringer on your voice terminal

●Green light next to [ Select ] winks; current ringing pattern plays and repeats every 4 seconds

●Display shows [ Personal Ring #x ] (x will be a number from 1 to 8)

3Continue to press [ Conference Ring ] to cycle through all 8 ringing patterns

4When you hear the desired ringing pattern, press [ Select ] again

●Your new ring is set; green light next to [ Select ] goes off

Note: If you receive a call, go off-hook, or lose power during selection, process is interrupted and you must start again. If you lose power after you have selected your personalized ring, you will have to select your ring pattern again.

1To raise the volume, press the right half of the Volume control button labeled [ ▲ ] ;

to lower the volume, press the left half of the Volume control button labeled [ ▼ ]

●Display shows [ Ringer L > > > > H ] (There are 8 possible volume settings. On the display, 1 arrow is the lowest setting, and 8 arrows is the highest setting)

22