Connecting Paging,
and Call Reporting (SMDR) Devices
Only steps for connection to the processor module are provided here. Refer to Chapter 4 of the PARTNER Plus Programming and Use guide and the manufacturer’s instructions for additional information on installing, programming, and using these devices.
Paging System
1 Insert the modular plug into the PAGE jack on the processor module.
2 Route the cord as you did for line and extension cords, then connect it to the paging system.
Music-on-Hold Audio Source
If you use equipment that rebroadcasts music or other copyrighted materials, you may be required to obtain a license from a third party such as ASCAP or BMI. Or you can purchase a Magic On Hold system from AT&T, which does not require you to obtain such a license.
1 A) Insert an RCA phono plug into the MUSIC ON HOLD jack on the processor module.
B)Route the cord as you did for line and extension cords, and then connect it to the audio source.
2 A) First set the unit’s volume to the lowest setting. Use
a flathead screwdriver to turn the volume control on the processor module counterclockwise until it stops.
B)Place a call on hold and listen while adjusting the volume, clockwise. If you do not hear music at any setting, check “Music On Hold (#602)” in Chapter 5 of the PARTNER Plus Communications System Programming and Use guide.
Call Reporting (SMDR) Printer
1 Insert one end of a D8W modular cord into the SMDR jack on the processor module.
2 Plug the other end into an AT&T 355A adapter and then plug the 355A adapter into the
PAGE Jack
Paging System (optional)
Volume Control
MUSIC ON HOLD
Jack
Audio Source
(optional)
SMDR Jack
AT&T
Call Accounting Terminal Printer
(optional)
Installation Procedures 15