AT&T 2448 installation instructions

Page 4

11.Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions:

when the power supply cord or plug is damaged or frayed.

if liquid has been spilled into the product.

if the product has been exposed to rain or water.

if the product has been dropped or the housing has been damaged.

if the product exhibits a distinct change in performance.

12.Avoid using a telephone during an electrical storm. There may be a remote risk of electric shock from lightning.

13.Do not use the telephone in the vicinity of a gas leak. To report a gas leak, use a telephone away from the area of the leak.

Basic safety precautions should always be followed when your telephone equipment is installed.

WARNING: The SPIRIT Communications System, Model 2448 must be installed by an AT&T service technician or a qualified installer.

WARNING: If you need to install a SPIRIT Communications System telephone in a different building but not more than 1000 feet from the control unit, In Range-Out of Building (IROB) protectors, AT&T Order Number 31304 (TII Model 371 or ITW Model SP69073), are required. The IROB protectors must be installed by an AT&T service technician or a qualified installer. Contact your AT&T representative for additional information.

1.Never install telephone wiring during a lightning storm.

2.Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.

3.Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.

4.Use caution when installing or modifying telephone lines.

5.Do not attach the power supply cord to building surfaces.

SAVE THESE INSTRUCTIONS

Image 4
Contents AT&T Page Important Safety Instructions Page Introduction Installation Attach Expansion Unit to Main Controller Mounting Holes and Distances Refer to Part D of Step